Saving as a .dxf file

[Damon Nabors]

Its been a while since I tried this but I thought you could take a part into the parts editor and create your geometry and then save the geometry as a dxf file. I can only get a x_t extention to show up.
Maybe I dreamed this.

Thanks,
Damon

[Kerry Fullington]

Damon,

You can open a .dxf file but it will save as the x_t tile which I think is a parasolid file.

Kerry

[Damon Nabors]

Thanks kerry, I was hoping I could save the geometry as a dxf file but now that I think about it, that has been covered to prevent people from saving as a dxf and cutting on competitor machines.

Thanks again,

Damon