HELP I can not open the software I put the(Disk 5)_it came 8-13-08 and ran repair.
Here is what comes up.I did back up the hole file
Of all days I have to show it at 2:30 today They OK it put the Doc. wants to see it all in black.
I can not open the software
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
I can not open the software
- Attachments
-
- EC_Down.jpg (43.51 KiB) Viewed 3523 times
-
- Handicapped Cabinets_1.JPG (30.86 KiB) Viewed 3523 times
-
- All the Cabinets_Handicapped_6-8-09.JPG (15.16 KiB) Viewed 3539 times
-
Larry Epplin
- Thermwood Team
- Posts: 668
- Joined: Tue, May 17 2005, 12:44PM
- Location: Thermwood
Re: I can not open the software
Hi George. You should run the latest update after a repair to insure all files are up to date. If it asks you to remove on the first try go ahead and do that. It does this because you have ran the update in the past. Then after the remove, run it again. That should get you going.
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: I can not open the software
I Thank You Larry and the girls Thank You
- Attachments
-
- The girl club.gif (156.01 KiB) Viewed 3486 times
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: I can not open the software
Thank You again Larry
When I did the repair with the disk all I lost was the edge banding stock image on (generic) an I just put it back
When I did the repair with the disk all I lost was the edge banding stock image on (generic) an I just put it back
