I'm designing a frameless job and am having trouble. The cabinet in question is a 6 drawer bath vanity, and when I add the doors, the software gives me overlays that are different from what I specify.
For example, when I add a top drawer front and specify the following reveals:
top 1/4"
left 1/8"
right 7/16"
I get instead a right reveal of 13/32".
Any idea what's up?
Cab is attached.
Not getting the overlays I specify
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
Not getting the overlays I specify
- Attachments
-
- VB6D6034.5BD.hsf
- (300.02 KiB) Downloaded 532 times
-
Rick Palechuk
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: Not getting the overlays I specify
Tim, I took it to the LDE and the overlay shows 5/16 over the partition, 1/4 top, 1/8 side. The fronts look like there centering over the partition properly. Did it say 13/32 in the construction settings?
