Glass panel door

[kenny gumm]

How do you create a glass panel door from part editor or how do you load the image for a glass panel door?

[Gary Puckett]

You can get a frame door frame with or without glass in the Door/Drawer selector ( Conestoga ) General Tab bottom left hand corner

Gary

[Rick Palechuk]

Kenny, are you looking for a glass image?

[kenny gumm]

You can get a frame door frame with or without glass in the Door/Drawer selector ( Conestoga ) General Tab bottom left hand corner

Gary

That worked great but I can't get the newly created door applied to my cabinet.Any suggestions?

[kenny gumm]

Kenny, are you looking for a glass image?

Originally yes but the other suggestion worked.Thanks

[Gary Puckett]

Kenny,

Just take your cabinet to the Door/Drawer editor chose the door you want, and click on the opening and the door will be there.

Gary

[kenny gumm]

Kenny,

Just take your cabinet to the Door/Drawer editor chose the door you want, and click on the opening and the door will be there.

Gary

Wow I was ready to pull my hair out then I finally figured out that I had to delete the original doors from the cabinet before the new doors could be imported.Is there an easy way to change the construction material on the entire cabinet?I just realized that I made this cabinet in red oak and the customer is wanting solid cherry.And is there a way to eliminate the toe kick?
Thanks,Kenny

[Gary Puckett]

Yes you can do all that in the cabinet editor on the construction setting tab.

Gary

[kenny gumm]

Yes you can do all that in the cabinet editor on the construction setting tab.

Gary

Thanks that worked great.