Whiteside 3606

Josh Rayburn · Post by **Josh Rayburn** » Tue, Oct 20 2009, 7:39AM

Would anyone happen to have a .tol file for this Whiteside #3606?
Thanks!

Gary Puckett · Post by **Gary Puckett** » Tue, Oct 20 2009, 10:07AM

There is one close in the part editor ( whiteside tool profiles) .But you are probaly going to have to make the tool yourself.

Gary

Gary Puckett · Post by **Gary Puckett** » Tue, Oct 20 2009, 6:21PM

I hope when V6 does show up , they made drawing a tool a lot easier. I have been trying to create this tool for a member and having no luck.Their is a broken line someware and I can't find it. Here is the profile the number is 3606
OH I did not use a spline, I used two 3/16 Rad.

Gary

George Davidson · Post by **George Davidson** » Tue, Oct 20 2009, 8:42PM

Whiteside #3606

Kerry Fullington · Post by **Kerry Fullington** » Wed, Oct 21 2009, 6:29AM

Gary,

Send me your x_t file of the tool you are trying to create with the broken line. I'll see if I can fix it.

Kerry

Josh Rayburn · Post by **Josh Rayburn** » Thu, Nov 12 2009, 3:11PM

forgot to say thanks guys, i always appreciate the help

Thermwood / eCabinet Systems

Whiteside 3606

Whiteside 3606

Re: Whiteside 3606

Re: Whiteside 3606

Re: Whiteside 3606

Re: Whiteside 3606

Re: Whiteside 3606