Cabinets, wall and appliances disappearing

Donald Thomson · Post by **Donald Thomson** » Sat, Mar 13 2010, 12:30PM

I'm working on designing a simple kitchen layout in V6B2. I can rotate design view and see everything intack on walls. When I go to Presentation mode a wall, its cabinets and appliance do not show up. I know they are all there but for some reason can't get them to display. I've done all the association stuff to no avail. Is this a known issue?

Mark McCallum · Post by **Mark McCallum** » Sat, Mar 13 2010, 5:08PM

Hi Don
I'm just learning the room editor at the moment but I have a small job I am drawing with a oven and dishwasher. They show up in both modes for me.

Just a thought,If you haven't already, try right click and choose restore all, while in render mode.
Good luck

Donald Thomson · Post by **Donald Thomson** » Sat, Mar 13 2010, 8:25PM

Thanks Mark - I'll give that a try.

Kerry Fullington · Post by **Kerry Fullington** » Sun, Mar 14 2010, 9:58AM

Don,

Mark is correct, you have hidden a wall while in render mode. It will also make any cabinets etc. associated to that wall disappear when you render the view with the wall hidden.

Kerry

Thermwood / eCabinet Systems

Cabinets, wall and appliances disappearing

Cabinets, wall and appliances disappearing

Re: Cabinets, wall and appliances disappearing

Re: Cabinets, wall and appliances disappearing

Re: Cabinets, wall and appliances disappearing