Hinges not showing up

[Tom Nienow]

Just started a new design in V6B3 and when I add doors to a cabinet the default hinges don't show up in th cost sheet, they appear in the cabinet buy list but as a quantity of zero. If you manually add the hinges & update quantities they then come into play, seems the should be there when you add a door instead of going through another step, always used to do it that way.

[Rick Deskins]

Can you give some steps on what you are doing?

ex.
load std base frameless
go to door/drawer editor
add default hinge and hinge pattern in Item Window
add hinged door
go back to main
click on cabinet buy list
click on cost list

[Jon Dieterlen]

I am having the same issue. Drawer glides show up, but the hinges are shown w/quantity of zero.


Jon

[Rick Deskins]

Gives some steps or post a cabinet file please.

[Tom Nienow]

Attached is a cabinet that this problem occurs on, I take any cabinet, one I have already created or a standard cabinet, go to door/draw editor, set a default hinge, add door(s), check cabinet buy list, hinges show up as 0, in cost sheet hinges are non-existant, slides & mounts show up.

[Dan Calvert]

I had this problem but after I selected a hole pattern the hinges showed up on the cost sheet.

[Kerry Fullington]

Rick,

As a side note, this is another cabinet that I am unable to open. There is one hardware item that diesn't have a hardware type listed and I cannot add the hardware or remove it from the cabinet..

Clipboard011.jpg (103.6 KiB) Viewed 12816 times

[Ryan Callahan]

Tom,

It appears as there is an issue with getting hinges to add to doors. I will get this addressed in the next build.
I was able to find a work around for now. Simply add any hinge pattern and the hinges will be automatically added to the cabinet as expected. Of course, if you plan to take the to a machine, you will want to use the correct pattern for this.

Thanks for posting.