Internal Error 1500

[Zach Froble]

I know the offices are closed for the Holiday, so I was wondering if anyone on the forum could help me out. I just got an error message "Internal Error 1500. Report to Thermwood". I am getting the error after I try to home the machine. It seems the x-axis doesn't want to return to zero. I had some jobs I wanted to run over the weekend so any help would be greatly appreciated.

Thanks,
Zach

[Will Williamson]

Check if your sensor has grease on it.

[Zach Froble]

I to the problem fixed. My c-markers were out of alignment. I adjusted them and homed the machine and everything is working fine.

Wil,

Thanks for the reply. I thought the sensor might have been the problem at first too. But I checked all the inputs and everything seemed to be working there. I remember having a problem like this a few years back after moving the machine to a different location. When I hit the E-stop the belt must have slipped at the encoder, which threw my c-markers off a hair.

Zach