Adding a fillet to an internal corner??

Dale Wills · Post by **Dale Wills** » Thu, Apr 15 2010, 6:42AM

Hi,
It's been some time since I have had to put a fillet onto an internal corner and was left scratching my head after I couldn't get it to work. The attached shelf needs a 50mm fillet on the internal corner the same as the two external corner fillets which works as per norm. But when I went to fillet the internal corner nothing happens. I have done plenty of these on previous versions of eCabs and was wondering if this is a program error. Can anyone shed some light on whats going on here?
Thanks,
Dale

Kerry Fullington · Post by **Kerry Fullington** » Thu, Apr 15 2010, 6:47AM

Dale,

This has been broken in version 6. It has been reported several times but I was told it isn't very high on the "Fix" list.

Kerry

Rick Deskins · Post by **Rick Deskins** » Thu, Apr 15 2010, 8:39AM

Fixed in next release

Dale Wills · Post by **Dale Wills** » Sun, Apr 18 2010, 5:45AM

Thanks guys

JohnLashuay · Post by **JohnLashuay** » Mon, Apr 19 2010, 8:00AM

Doing a fillet on an internal corner does work in the contour mode.

Create the edges of that part the fillet it. That should work in the mean time.

Thermwood / eCabinet Systems

Adding a fillet to an internal corner??

Adding a fillet to an internal corner??

Re: Adding a fillet to an internal corner??

Re: Adding a fillet to an internal corner??

Re: Adding a fillet to an internal corner??

Re: Adding a fillet to an internal corner??