Dado ramp-in distance appears too short by a large factor. I'm guessing in the region of 25.4 times too short
Anyone else got this, or am I doing something wrong ?
Thanks
Matt
CN5.60 metric ramp-in
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
JohnLashuay
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
Re: CN5.60 metric ramp-in
Matt, our Dado ramp in length is set at 6". Not sure in mm, but it didn't change with the updated CN.
-John
-John
-
Matt Snowball
- Junior Member
- Posts: 30
- Joined: Wed, Jun 04 2008, 5:00AM
Re: CN5.60 metric ramp-in
Thanks for the reply John - this may be a metric-only issue.
If I want the machine to create an actual ramp-in length of 150mm, I need to enter a value of, say around 3750mm into CN. The fact that this is a factor of around 25 leads me to suspect a mm-inch conversion.
I have upgraded directly from CN5.48 to CN5.60, if that helps narrow it down.
Thanks
Matt
If I want the machine to create an actual ramp-in length of 150mm, I need to enter a value of, say around 3750mm into CN. The fact that this is a factor of around 25 leads me to suspect a mm-inch conversion.
I have upgraded directly from CN5.48 to CN5.60, if that helps narrow it down.
Thanks
Matt
-
Larry Epplin
- Thermwood Team
- Posts: 668
- Joined: Tue, May 17 2005, 12:44PM
- Location: Thermwood
Re: CN5.60 metric ramp-in
We have found the problem. It will be fixed in the next update. Thank you for the input.
