Toe Kick configuration!
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Eric Garrett
- New Member
- Posts: 1
- Joined: Wed, Dec 15 2010, 9:53AM
- Company Name: Garrett Industrial Inc
Toe Kick configuration!
I am trying to install a toe kick which is on the front edge of the cabinet sides and flush to the outside! I only see it butting or dato to the inside. Can I change this?
-
Mark McCallum
- Guru Member
- Posts: 563
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
Re: Toe Kick configuration!
Hi Eric.
Welcome to the forum.
I set the toe kick construction to full dado, and then press the front toe construction parameters to go to the next window. Set the depth to the thickness of your end material. I think this will give you the look you want, but I am not sure how it would cut on a CNC
Welcome to the forum.
I set the toe kick construction to full dado, and then press the front toe construction parameters to go to the next window. Set the depth to the thickness of your end material. I think this will give you the look you want, but I am not sure how it would cut on a CNC
-
Kerry Fullington
- Wizard Member
- Posts: 4763
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Toe Kick configuration!
Eric,
You can also set your left and right toe kick construction to butt and then enter a negative left and right inset that equals the thickness of your end material.
This will not display graphically correct but will give you the correct cutlist and will machine properly.
Kerry
You can also set your left and right toe kick construction to butt and then enter a negative left and right inset that equals the thickness of your end material.
This will not display graphically correct but will give you the correct cutlist and will machine properly.
Kerry
