Corner cabinet inset doors

[Jon Dieterlen]

I have a framed angle front corner cabinet that will not size the door properly when the door inset is set to 3/4". The overlap changes to gap, as it should in the door editor, but when it returns to the main area, the door changes sizes, and the gap is returned to overlap.

I have the right and left stile set to a negative 1/2" scribe so the top and bottom rails are sized properly. If I change the scribe to 0, the inset and gap settings work correctly.

Is this a known issue?

Thanks, Jon

[Scott G Vaal]

Jon,

No, this was not a known issue. I have it documented now and it should be resolved for the next release. Thanks for the report.