Hi
Could someone help with converting a DXF to STL?
I downloaded Accutran and loaded in the following 3d dxf file for a viking refrigerator but when it loads in Accutran it only shows the nameplate. When I look at the file with a solidworks dxf viewer it shows all of the views for the refrigerator. Not sure if it's something I'm not doing right or if the file is bad. I download it from Viking's Site.
Thanks!
Nick
Help converting DXF to STL
Moderators: Jason Susnjara, Clint Buechlein, Jason Susnjara, Clint Buechlein
-
Nick Sollecito
- Junior Member
- Posts: 51
- Joined: Sun, Mar 05 2006, 11:03AM
- Location: Swansea, MA
- Contact:
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: Help converting DXF to STL
VCWB300R
In STL
In STL
- Attachments
-
- VCWB300R.zip
- (7.41 MiB) Downloaded 764 times
-
-
Nick Sollecito
- Junior Member
- Posts: 51
- Joined: Sun, Mar 05 2006, 11:03AM
- Location: Swansea, MA
- Contact:
Re: Help converting DXF to STL
Hi George,
Thank you for doing the conversion. Much appreciated. I would really like to know how you were able to find the parts of the file to convert. When I opened the file in Accutran I could only see the Viking nameplate.
Thanks
Nick
Thank you for doing the conversion. Much appreciated. I would really like to know how you were able to find the parts of the file to convert. When I opened the file in Accutran I could only see the Viking nameplate.
Thanks
Nick
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: Help converting DXF to STL
Hi Nick
Here is how it opens up in just 2 of my Cad programs
1-TurboCAD Professional
2-Punch! ViaCAD
I would say you need to change something in your Accutran then it will open ok
Here is how it opens up in just 2 of my Cad programs
1-TurboCAD Professional
2-Punch! ViaCAD
I would say you need to change something in your Accutran then it will open ok
- Attachments
-
-
-
Nick Sollecito
- Junior Member
- Posts: 51
- Joined: Sun, Mar 05 2006, 11:03AM
- Location: Swansea, MA
- Contact:
Re: Help converting DXF to STL
I'll play around with it. I just downloaded Accutran and I am not familiar with it.
On the files that you sent me...
I unzipped the files and put all the stl files in the Appliance/Refrigerator folder. I also put the jpg in the same folder. I cannot see the wine refrigerator in the refrigerator list. Am I doing this correctly?
Thanks!
Nick
On the files that you sent me...
I unzipped the files and put all the stl files in the Appliance/Refrigerator folder. I also put the jpg in the same folder. I cannot see the wine refrigerator in the refrigerator list. Am I doing this correctly?
Thanks!
Nick