Nesting sequsnced flat panel doors?

Bill LiCausi · Post by **Bill LiCausi** » Tue, Mar 01 2011, 10:37AM

Can flat panel doors be nested on sequenced sheets to keep the grain matched ? I can attach the job if anyone needs to see.
thanks for any help

Josh Rayburn · Post by **Josh Rayburn** » Tue, Mar 01 2011, 1:09PM

Bill,
Slab doors can be "grouped" on a per cabinet basis, but not on a job basis or per elevation.
Hope this helps
jnr

Will Williamson · Post by **Will Williamson** » Tue, Mar 01 2011, 2:32PM

Use DXF file to locate doors on sheets send to Control Nest

Josh Rayburn · Post by **Josh Rayburn** » Tue, Mar 01 2011, 4:48PM

Yeah, Will - that's what I would do too. Wouldn't even think twice about it.
jnr

Bill LiCausi · Post by **Bill LiCausi** » Thu, Mar 03 2011, 1:54PM

The DXF file sounds great, just not sure how to do that. Forgive me I'm just a novice.

Will Williamson · Post by **Will Williamson** » Thu, Mar 03 2011, 4:57PM

Are you a Thermwood owner?

Bill LiCausi · Post by **Bill LiCausi** » Thu, Mar 03 2011, 6:20PM

I don't own a Thermwood yet. I have a shop sabre and am playing with eCabs while considering an upgrade to thermwood. I have taken the 3-day eCabs class.

Gary Campbell · Post by **Gary Campbell** » Thu, Mar 03 2011, 6:23PM

I have a related question. I will soon start cutting 124 identical 3 draw bases for a facility. The doors are made from woodgrained melamine. I know how to group them. Is there a way to have the labels mark the groups without having to assign each cabinet with a unique name/number?

Michael S Murray · Post by **Michael S Murray** » Fri, Mar 04 2011, 7:27PM

Gary,
You could draw a room and drop all of them into it rather than a batch, then e-cabs would assign a cabinet number that would show on your label or printout.
If you use this I would probably do it in 4 rooms or so,room 1, room 2, etc.
I have trouble when you get up around 100 cabinets or more.
Might be a better way, but I am tired and not much help right now.....

Gary Campbell · Post by **Gary Campbell** » Fri, Mar 04 2011, 9:32PM

Mike...
Yer the man! That works just fine. I was planning on doing them in batches of 10 or 12, but the room works better. Each room can have a unique name or number and, as you say, each cabinet then is also numbered.

Thanks, Gary

Thermwood / eCabinet Systems

Nesting sequsnced flat panel doors?

Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?

Re: Nesting sequsnced flat panel doors?