Getting accurate drawer box sizes
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Mike Slowik
- New Member
- Posts: 16
- Joined: Fri, Jan 21 2011, 12:12PM
- Company Name: The Cabinetworks LLC
Getting accurate drawer box sizes
When I bring a cabinet into the editor and take a look at dbx's and drawers, they are the correct size, but from the buy list the width, which is accurate, becomes the height also, which is wrong. How can I correct this?
-
Scott G Vaal
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Getting accurate drawer box sizes
Mike,
Sorry, but this is actually a glitch. I have it listed and it will be resolved in the next release. The costing is being calculated correctly, it is just the display value for H in the buy lists (as you mention). Until the fix, you can get the accurate sizes for your alternate source drawer boxes in the cut list (see section {Drawer Boxes - Alternate Source} of the cut list). Sorry for the inconvenience.
Sorry, but this is actually a glitch. I have it listed and it will be resolved in the next release. The costing is being calculated correctly, it is just the display value for H in the buy lists (as you mention). Until the fix, you can get the accurate sizes for your alternate source drawer boxes in the cut list (see section {Drawer Boxes - Alternate Source} of the cut list). Sorry for the inconvenience.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
-
Mike Slowik
- New Member
- Posts: 16
- Joined: Fri, Jan 21 2011, 12:12PM
- Company Name: The Cabinetworks LLC
Re: Getting accurate drawer box sizes
No prob, just good to know it wasn't some setting or something I'm doing wrong.
Thanks
Thanks
