Once I have successfully loaded this file and added the material I want to use. Control nesting wants to nest the part 90 degrees to what I am expecting. In other words, the length of the material is running along the y-axis instead of the X. This is problematic as the length of the part exceeds the table parameters. Im sure the dxf file has the piece oriented correctly. Any ideas on settings that may cause this?
Thanks,
Daniel in New Orleans
DXF File nest issue
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Daniel Bell
- New Member
- Posts: 16
- Joined: Thu, Apr 14 2011, 11:04AM
- Company Name: Central City Millworks
- Country: UNITED STATES
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: DXF File nest issue
Daniel,
Has this been addressed yet?
If not, perhaps you can attach a copy of the DXF in question.
Ignore this... I did not see the second posting....
Has this been addressed yet?
If not, perhaps you can attach a copy of the DXF in question.
Ignore this... I did not see the second posting....