KD/RTAs

Georgi Baltov · Post by **Georgi Baltov** » Thu, Jul 14 2011, 2:48PM

Hello Everybody.

Has anyone figured out a way to make KD/RTAs work with the 32mm system. Say, start from the front edge of the cabinet only and place holes in 32mm increments only. I want to make dowel construction and need to figure out a way to cheat the offsets and the max distance. It splits the difference between the front and back hole and drills a hole in the middle. It would have been much better if it was an increment instead of max distance.

Thanks for the help

Georgi Baltov · Post by **Georgi Baltov** » Thu, Jul 14 2011, 3:50PM

I got it. Thanks to everyone that thought on it though

Thermwood / eCabinet Systems

KD/RTAs

KD/RTAs

Re: KD/RTAs