pie shape lower

FredHirsch · Post by **FredHirsch** » Tue, Oct 11 2011, 11:50PM

Is there any way to do a pie shaped lower cabinet with less than 90degree angle? We have a number of these to do and I can't seem to figure a way to do them. Front of the box is the 20" leg.
Thanks,
Fred

Kerry Fullington · Post by **Kerry Fullington** » Wed, Oct 12 2011, 6:31AM

Fred,

Is this what you are looking for. I will have to play with it a bit more to get your exact measurements.

FredHirsch · Post by **FredHirsch** » Wed, Oct 12 2011, 10:38AM

Kerry that is it. Measurements above are not necessarily what I need. I'm mostly just trying to figure out how you did that. We get all different measurements and right now in the dark ages esentially making on table saw.
Thx
Fred

Kerry Fullington · Post by **Kerry Fullington** » Wed, Oct 12 2011, 7:33PM

Fred,

I have attached the cabinet I was playing with for you to look at. I am not sure it will work though. I had to use a display panel for the back so it won't automatically re-size.
I will keep playing with it.

Kerry

JohnLashuay · Post by **JohnLashuay** » Thu, Oct 13 2011, 9:15AM

Kerry, is there any way to use a back in place of the display panel?

Kerry Fullington · Post by **Kerry Fullington** » Thu, Oct 13 2011, 11:48AM

John,

This was done using a corner cabinet and with the three piece back I can't get it to work. The center back is just a bit short to make the cuts.

I am going to try this using a miter fold.

Kerry

FredHirsch · Post by **FredHirsch** » Tue, Oct 25 2011, 12:11PM

Kerry,
That is it. I still need to get my head around the corner cab numbers and what all changes. Display panel is not a problem.
Thanks,
Fred

Thermwood / eCabinet Systems

pie shape lower

pie shape lower

Re: pie shape lower

Re: pie shape lower

Re: pie shape lower

Re: pie shape lower

Re: pie shape lower

Re: pie shape lower