Hi Forum Members an admins,
We have the C67S343, 5 axis.
I was trying to fix the "“” ERROR 1500 Internal Error, Report to Thermwood ””, so I investigate in the forum and I foun the Procedure to fix it (haven't finished yet), but then It came with anothe Error wich i can find in the forum and am asking for help:
• Axis 4or 5 Out limit, Air Pressure Low, VSD Fault
see the atached document below
kind regards
Gorka.
• Axis 4or 5 Out limit, Air Pressure Low, VSD Fault
Moderators: Mike Iubelt, Jason Susnjara, Clint Buechlein, Mike Iubelt, Jason Susnjara, Clint Buechlein
-
Gorka Maidagan
- New Member
- Posts: 3
- Joined: Wed, Nov 30 2011, 5:31PM
- Company Name: Seeley International
- Country: AUSTRALIA
- Location: 112 O'sullivan Beach Rd Lonsdale SA 5160
- Contact:
-
Gorka Maidagan
- New Member
- Posts: 3
- Joined: Wed, Nov 30 2011, 5:31PM
- Company Name: Seeley International
- Country: AUSTRALIA
- Location: 112 O'sullivan Beach Rd Lonsdale SA 5160
- Contact:
Re: • Axis 4or 5 Out limit, Air Pressure Low, VSD Fault
Hi All, and special thanks to thermwood, everything is fine and running.....