Dears..............
plz help me with this error,
i'm trying to make homing but the maching stops and showing,
Error 1514 : B Axis C – Marker adjust value is too largely Negative. Plz report THERMWOOD Corp
Plz help me to rectify this problem.
HOMING ERROR
Moderators: Mike Iubelt, Jason Susnjara, Clint Buechlein, Mike Iubelt, Jason Susnjara, Clint Buechlein
-
Mohammed riyas
- New Member
- Posts: 8
- Joined: Sun, Jan 01 2012, 3:38AM
- Company Name: ARTIC
- Country: SAUDI ARABIA
- Location: riyadh
- Contact:
-
Daniel Vonderheide
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: HOMING ERROR
Mohammed,
The error that you are getting is because there is too large of a value for the B axis in your c-marker adjustment table. If you have a large value in the table because of alignments, you will need to re-belt and realign the axis.
The error that you are getting is because there is too large of a value for the B axis in your c-marker adjustment table. If you have a large value in the table because of alignments, you will need to re-belt and realign the axis.
-
Mohammed riyas
- New Member
- Posts: 8
- Joined: Sun, Jan 01 2012, 3:38AM
- Company Name: ARTIC
- Country: SAUDI ARABIA
- Location: riyadh
- Contact:
Re: HOMING ERROR
Dear Mr.Daniel Vonderheide,
Thanks a lot for your needfull help.
Thanks a lot for your needfull help.
