Unsaved cabinets even after I've just saved it...

[BenRatt]

I've had a glitch for a while now, whenever I close a cabinet in cabinet editor I always get the message "Are you sure you want to start over? There are unsaved cabinets in the current assembly". It does this when I haven't made any changes. I can open a cabinet and then close it without doing anything to it and I get this message. Also, I'm not working on an assembly, it's just a cabinet. It does it even after I've just saved the cabinet and I'm trying to close it out. Anyone else have this issue? It was doing this before build 8.

[Josh Rayburn]

Yes Ben it always does that. Frustrating.
jnr

[Donald Thomson]

You will also get this same annoying dialog when you exit from working on a batch. Save the batch, then try to exit eCabs. It will ask you if you want to save the job, again.