Lock Dado 100% thickness causes unnecessary back flips. If you make thickness 50% behaves accordingly. Interestingly, if you just do 100% dado everything OK. Is this a bug or am I missing a setting somewhere?
Thx
Fred
Lock Dado 100% Thickness
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
FredHirsch
- Senior Member
- Posts: 167
- Joined: Tue, Oct 03 2006, 6:51PM
- Location: Phoenix, AZ
- Contact:
Lock Dado 100% Thickness
Fred Hirsch
-
Jason Stephenson
- Junior Member
- Posts: 36
- Joined: Mon, Aug 30 2010, 4:10PM
- Company Name: Marks Joinery
Re: Lock Dado 100% Thickness
im having same issue i put the locked dado tennon gap at 0 and it does a flip op but only does the dado on the shelf at about 1 to 2mm deep which is painfull for us so ive just gone back to doing 100% dado and getting the assemblers to drill hole in the dado if there was a way to get around this, this would be great would save even more time for our assemblers hope this helps
