Presentation view causes ecabinets to shut down

[Leo Graywacz]

Never mind. It's crashing again. I tried adding some lights into the room and it crashed when I added them.

[Leo Graywacz]

The Dome ceiling light is one I can't place in the job at all. The chandelier I can put in the room and it doesn't crash. I can get it to render and adjust the intensity of the lights and rerender and it works. As soon as I try to move the room perspective around it crashes. If I don't have the lights in there most of the time I can get to move the room perspective and rerender without a crash.

I rebooted my computer and didn't load in my usual bevy of programs that I always have running. Not sure if this helped or not as I was able to make the perspective change in a render before I rebooted. Just not with the dome light. And only after I created new cabinets (from old seeds)

[Leo Graywacz]

I might have found a work around. Graphic properties and then to trouble shooting. Reduce the acceleration to the minimum. Load in eCabs. Load your job. Go back to the trouble shooting and then raise it back up to full acceleration. Seems to work. I know if I put it down 3 notches I can use it without playing around evertime when I load it. But that will affect all my programs.

We'll see what happens.