Is it possible in the next version of the controll nesting to be able to change the name of Off-fall material to match.
we use the size of the material in the name, therefore a 3/4'' MDF sheet 5x10 off-fall could be used in a job using only 3/4'' MDF 4x8 sheets
This would save a couple minutes each time creating a new custom sheet to match the existing off-fall!!!!
Thanks,
Stéphane
Control Nesting Off-fall Material
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 24
- Joined: Fri, Dec 14 2012, 10:08AM
- Company Name: Aspec
- Country: CANADA
- Location: St-Odilon