Tooling Problem

Griffin OHara · Post by **Griffin OHara** » Tue, Jul 08 2014, 7:12AM

I'm cutting a panel with lots of pocket cuts on it and i want it to cut most of it with a bigger bit then the 1/8 to clean the corners up. i wondering if this is possible.

Daniel Odom · Post by **Daniel Odom** » Tue, Jul 08 2014, 10:58AM

What program are you trying to design it in? Ecabinets? Or are you just using dxf importing?

Griffin OHara · Post by **Griffin OHara** » Tue, Jul 08 2014, 2:22PM

I'm using eCabinets

Josh Rayburn · Post by **Josh Rayburn** » Tue, Jul 08 2014, 3:49PM

Have you considered trying it with a layered .dxf file instead?

Thermwood / eCabinet Systems

Tooling Problem

Tooling Problem

Re: Tooling Problem

Re: Tooling Problem

Re: Tooling Problem