Apron front single

[Wally Schneeberger]

Does anyone have a HSF for a Stainless steel apron front sink - 36" ?? I like the Kraus but don't know how to make & save one.
https://www.directsinks.com/kitchen/kit ... l?___SID=U .

[Wally Schneeberger]

Anyone???

[Mark McCallum]

Hi Wally.
Ive been playing around with stl's a little bit
Not sure if this is workable but see how it goes

[Wally Schneeberger]

Thanks Mark -- I'll give it a try!!

[Wally Schneeberger]

Mark -- there is something wrong with that HSF. It screws up my plan and I have to hit UNDO before my screen goes back to normal have a look at this and the big circle behind the plan--

[Mark McCallum]

Hi Wally
I see what you mean.
That round circle is the drain hole
The sink was about 19meters wide so the whole kitchen was in the sink.
I took it back into the part editor and have resized the sink so hopefully this one might work.

[Scott Marshburn]

You do have to be careful with models downloaded from the 3D Warehouse. Sometimes they are quite large. So be sure to scale them before exporting.

[Wally Schneeberger]

Hi Wally
I see what you mean.
That round circle is the drain hole
The sink was about 19meters wide so the whole kitchen was in the sink.
I took it back into the part editor and have resized the sink so hopefully this one might work.

You did GOOD Mark!! LOL. It works well now -- have a look --

[Mark McCallum]

Hi Wally
No problem.
That's a nice decent sized kitchen.
You have put a lot of effort into the presentation. It looks great! I hope you get the job.
I haven't actually seen stainless sinks like those, perhaps they will be the next big thing.
I thought you might have put the stone over the top of the sink edge.
I suppose they load the gap between the sink and the stone with silicon?

[Wally Schneeberger]

Mark -- it depends on what type of CT the customer picks. If it is Granite or solid surface then it is under mounted but if it is laminate I make a template and slide it in and silicone between the sink and counter. There is no gap to fill as the template is exact.