How can I stop in the middle of a job then start up where I left off.
Say I have a 20 sheet job and only get 12 cut before the end of the day and want to finish the last 8 sheets the next day. How would I do that?
Also how do I stop cutting on a sheet and then resume cutting?
Tom Peckham
Stopping mid job
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Tom Peckham
- New Member
- Posts: 5
- Joined: Mon, Feb 23 2015, 12:49PM
- Company Name: Alpne Cabinet and Woodwork
- Country: UNITED STATES
-
Scott G Vaal
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Stopping mid job
Tom,Tom Peckham wrote:How can I stop in the middle of a job then start up where I left off.
Say I have a 20 sheet job and only get 12 cut before the end of the day and want to finish the last 8 sheets the next day. How would I do that?
Also how do I stop cutting on a sheet and then resume cutting?
Tom Peckham
In Control Nesting, go to Settings and under Machine Settings check on the Sheet Selection Option. This will then prompt you at the start of each program to select a sheet to start machining on. You will of course have to re-CNC your job to get the program to have the option in it.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
-
Tom Peckham
- New Member
- Posts: 5
- Joined: Mon, Feb 23 2015, 12:49PM
- Company Name: Alpne Cabinet and Woodwork
- Country: UNITED STATES
Re: Stopping mid job
Thank you Scott. That is it.
