Hello,
When truing to write CNC, after it asks if I want to change material thickness, I run into a problem and it says Encountered an improper argument. Same when I try and save the .esj file, any thoughts please?
Thank you
Improper Argument
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Robert Pettit
- New Member
- Posts: 7
- Joined: Thu, Mar 14 2013, 7:51AM
- Company Name: Beagle and Potts
- Country: UNITED STATES
-
Mark Hesketh
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
Re: Improper Argument
do any of your material names include the " inch symbol? I have a vague memory of that being an issue for me in the past... If so, try removing that from you material names and running it again
Someone else chime in if I am mis-remembering
Someone else chime in if I am mis-remembering
-
Robert Pettit
- New Member
- Posts: 7
- Joined: Thu, Mar 14 2013, 7:51AM
- Company Name: Beagle and Potts
- Country: UNITED STATES
Re: Improper Argument
Thanks,
No, I have them all labeled 1/2 maple, 3/4 baltic birch, etc....
No, I have them all labeled 1/2 maple, 3/4 baltic birch, etc....
-
Mark Hesketh
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
Re: Improper Argument
Does your filename have any special characters in it? or any of the cabinet names?
-
Robert Pettit
- New Member
- Posts: 7
- Joined: Thu, Mar 14 2013, 7:51AM
- Company Name: Beagle and Potts
- Country: UNITED STATES
Re: Improper Argument
Nope,
Cabinets, 1,2,3, etc.
File clients name.
It's the first time with cabinets on this computer, I can't even CNC file the standard cabinets it comes loaded with. Ecabs 6 build 17. Running on Paralles on a mac. I have the same set up at the shop office and it's worked great. This is one a new laptop, first time running it on this computer. I tried to save the job file so I could email it to the shop and run it from there, but I can't even save the file with out running into the error message.
Thanks for your help
Cabinets, 1,2,3, etc.
File clients name.
It's the first time with cabinets on this computer, I can't even CNC file the standard cabinets it comes loaded with. Ecabs 6 build 17. Running on Paralles on a mac. I have the same set up at the shop office and it's worked great. This is one a new laptop, first time running it on this computer. I tried to save the job file so I could email it to the shop and run it from there, but I can't even save the file with out running into the error message.
Thanks for your help