Doors to part editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
JR Allen
- Junior Member
- Posts: 84
- Joined: Sun, Mar 16 2014, 1:48PM
- Company Name: JRs Woodworx
- Country: UNITED STATES
Doors to part editor
Hello all, Seeking some advice on how to place a trash hole cutout in a door panel. I've selected a door and exported but can not take to part editor to cut a hole. Been a while since I subscribed to the video area and not sure if the answer is there. Thanks in advance for any info.
-
Scott Marshburn
- Guru Member
- Posts: 867
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Re: Doors to part editor
Hi Jr.
The only doors that are supported in the part editor Are slab doors. If you are using a slab door then you can select it and then take it into the Part editor. Here you can create the geometry for the cutout. Then create a pocket.
The only doors that are supported in the part editor Are slab doors. If you are using a slab door then you can select it and then take it into the Part editor. Here you can create the geometry for the cutout. Then create a pocket.
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
-
JR Allen
- Junior Member
- Posts: 84
- Joined: Sun, Mar 16 2014, 1:48PM
- Company Name: JRs Woodworx
- Country: UNITED STATES
Re: Doors to part editor
Thanks Scott, need to do this in a raised panel just didn't want to try and recreate the RP & stile profile in a slab door.
