Hi,
Just came across that the formula settings when in shelf hole settings is giving incorrect values.
Ie: Cabinet width of 700mm, I go to apply holes on the back of a cabinet on the left inset with the formula: CabinetWidth/3 which should be 233.33mm but it says 5926.68mm?? Same happens on the right inset.
I am wanting to have 2 holes on the cabinet back divided evenly. Am I going about this wrong?
Thanks
Formula in hole settings
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 15
- Joined: Mon, Dec 08 2014, 11:13PM
- Company Name: Not Just Kitchens LTD
- Country: NEW ZEALAND