Interior walls
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 118
- Joined: Sun, Oct 19 2014, 8:33PM
- Company Name: Frank Raffaele and Sons Custom
- Country: UNITED STATES
Interior walls
Hello all. New to the software but do have some of the basics down. Trying to create a room and can build the perimeter walls but having trouble figuring out how to place my interior walls. For example I build a simple 18' x 24' rectangular room and want to build the two walls a specified distance that create the bathroom or a closet within the rectangular room. So far any interior walls I have been able to build have no dimension lines associated with them so I can't just select them and move them to a specified distance. Could use a little guidance.
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Interior walls
If you set your starting point to 0,0 to start building your walls you can calculate where you need your interior walls
and if you turn on your snap and set it to 1 inch it will make it a little easier
hope this helps
Tim
and if you turn on your snap and set it to 1 inch it will make it a little easier
hope this helps
Tim
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- Senior Member
- Posts: 118
- Joined: Sun, Oct 19 2014, 8:33PM
- Company Name: Frank Raffaele and Sons Custom
- Country: UNITED STATES
Re: Interior walls
Tim, Thank you. That helps. Do you know if there is any way to get dimension lines to these interior walls.
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: Interior walls
Not sure what you mean, should look like this Or if you need more, you can take the layout into the "Line Drawing Editor" and add all the measurments TimCarmen Addamo wrote:Tim, Thank you. That helps. Do you know if there is any way to get dimension lines to these interior walls.
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- Senior Member
- Posts: 118
- Joined: Sun, Oct 19 2014, 8:33PM
- Company Name: Frank Raffaele and Sons Custom
- Country: UNITED STATES
Re: Interior walls
Thanks again, Tim. Line editor is what I am after. Haven't gotten that far yet.