Converting a 3D DXF to STL

Leo Graywacz · Post by **Leo Graywacz** » Fri, Oct 28 2016, 3:26PM

I have a Kohler sink that has a 3D DXF file. I was able to load it into AutoCAD and then render it and it is a good representation.

I have tried a few online conversion programs, I get the STL file and load it into Display Part Editor. When I get it in there it is no longer hollow. The bowl is filled.

Anyone have any luck with these types of conversions?

Since I can't upload the DXF because it calls it an invalid file, here is the link to the file.

http://www.us.kohler.com/us/Brockway-3% ... 418116.htm

Mark McCallum · Post by **Mark McCallum** » Sat, Oct 29 2016, 5:54PM

Hi Leo
See if this one works

Leo Graywacz · Post by **Leo Graywacz** » Sat, Oct 29 2016, 10:14PM

Tried a few different ways. Kept coming up with an error.

Kerry Fullington · Post by **Kerry Fullington** » Sun, Oct 30 2016, 10:46AM

Leo,

Get Accutrans 3D to convert your files.

Leo Graywacz · Post by **Leo Graywacz** » Sun, Oct 30 2016, 5:04PM

Got a good image off that program. Thanks.

Thermwood / eCabinet Systems

Converting a 3D DXF to STL

Converting a 3D DXF to STL

Re: Converting a 3D DXF to STL

Re: Converting a 3D DXF to STL

Re: Converting a 3D DXF to STL

Re: Converting a 3D DXF to STL