why when you are cutting single sided material and there are operations on the B side but nothing on the A side can't B side be face up?
your flipping the sheet for no reason.
single sided material
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Thomas strembitsky
- Guru Member
- Posts: 307
- Joined: Fri, Jul 27 2012, 12:30PM
- Company Name: true form cabinets
- Country: CANADA
- Contact:
single sided material
Intel(R) Core(TM) i-13700K @ 2.70GHz 32.00 GB RAM
Windows 11 Professional 64-bit
http://www.trueform.ca
CS43 cnc
Windows 11 Professional 64-bit
http://www.trueform.ca
CS43 cnc
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: single sided material
Thomas,
I would assume that the material is left as is so that there is a consistent material orientation for the operator when loading - namely "Side B Down Against the Table". If what you are asking were an option - and I think it would be a good "user selectable" option in Settings, then the operator would have to pay close attention to the "LOAD MATERIAL" messages/dialogs to insure that the material was loaded with the correct face up.
If using this possible option in "auto-loading" situations, one would have to review the material face orientations beforehand and pre-stack the bundle accordingly before starting the run.
I would assume that the material is left as is so that there is a consistent material orientation for the operator when loading - namely "Side B Down Against the Table". If what you are asking were an option - and I think it would be a good "user selectable" option in Settings, then the operator would have to pay close attention to the "LOAD MATERIAL" messages/dialogs to insure that the material was loaded with the correct face up.
If using this possible option in "auto-loading" situations, one would have to review the material face orientations beforehand and pre-stack the bundle accordingly before starting the run.
