part editor closed contor, line info

[Marcel Thibodeau]

The line information has gone from the closed contour in the part editor? So if you draw a line and hover on it it used to give you the coordinates and the line length. Very handy for checking opening sizes. Seems to be gone now, is that right?

[Jeremy Schiffer]

It's still there, on my screen. At the very bottom. Maybe your window is larger than your screen and that info is pushed off the bottom?

[Marcel Thibodeau]

heck i checked and its there, but i could swear last week it wasn't. I don't understand, maybe because I was using the editor in the drawer box designer at the time... who knows....