Hi Everybody
Have you ever experienced anything like the pic attached?
The knife doesnt recognize the value of the wasteboard though being set up properly
Any help would be appreciated
Kim
The surface knife doesnt recognize wasteboard thickness
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: The surface knife doesnt recognize wasteboard thickness
Kim - Your generation of THM control does not automatically incorporate the WASTEBOARD thickness into the DAYLIGHT adjustments.
That generation of THM control also does not have the built-in FLYCUT function found on the newer machines. That machine is running X-SURF provided by CNC Automation to Canadian owners of early model Thermwoods.
In both instances, changes have to be made to your older tool change macros as your machine was restored back to factory settings with the replacement hard disk drive.
I believe our CNC Automation Service Group has been in contact with your company and a technician may have been scheduled to assist you.
That generation of THM control also does not have the built-in FLYCUT function found on the newer machines. That machine is running X-SURF provided by CNC Automation to Canadian owners of early model Thermwoods.
In both instances, changes have to be made to your older tool change macros as your machine was restored back to factory settings with the replacement hard disk drive.
I believe our CNC Automation Service Group has been in contact with your company and a technician may have been scheduled to assist you.
