Default Flycut Values
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 124
- Joined: Fri, Sep 22 2017, 7:49AM
- Company Name: Silverpine Cabinets
- Country: CANADA
Default Flycut Values
I was just wondering if there is a way to change the default amount that gets removed from the wasteboard during a flycut?
-
- Thermwood Team
- Posts: 719
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Default Flycut Values
Unfortunately there is not, I've put in a request with the software engineers for it though.
-Clint-
-Clint-
-
- Senior Member
- Posts: 124
- Joined: Fri, Sep 22 2017, 7:49AM
- Company Name: Silverpine Cabinets
- Country: CANADA
Re: Default Flycut Values
Thanks Clint. I know we're a little odd cause we use metric by default in our shop, so I would like to get a nice round number for the flycut, like 0.3mm instead of 0.254mm.
-
- Thermwood Team
- Posts: 719
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Default Flycut Values
Tommy,
I should have something that will work for you. I need your thm.ini located in C:\system. You can either post it here in a zipped folder or email it to cabinets@thermwood.com
-Clint-
I should have something that will work for you. I need your thm.ini located in C:\system. You can either post it here in a zipped folder or email it to cabinets@thermwood.com
-Clint-
-
- Senior Member
- Posts: 124
- Joined: Fri, Sep 22 2017, 7:49AM
- Company Name: Silverpine Cabinets
- Country: CANADA
Re: Default Flycut Values
Sorry I've been away from the shop for a couple weeks. Here's the file, looking forward to what you've got for me!
Thanks Clint!
Thanks Clint!
- Attachments
-
- THM.zip
- (931 Bytes) Downloaded 431 times
-
- Thermwood Team
- Posts: 719
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Default Flycut Values
Tommy,
Updated file attached. Make sure THM is shut down before you paste it back in.
-Clint-
Updated file attached. Make sure THM is shut down before you paste it back in.
-Clint-
- Attachments
-
- THM.zip
- (946 Bytes) Downloaded 421 times
-
- Senior Member
- Posts: 124
- Joined: Fri, Sep 22 2017, 7:49AM
- Company Name: Silverpine Cabinets
- Country: CANADA
Re: Default Flycut Values
Thanks a lot Cliff! Exactly what I wanted...
Have a great day!
Have a great day!