Manual head alignment

Gino Benjamin · Post by **Gino Benjamin** » Fri, Oct 15 2021, 2:31AM

Hi guys
I'm looking for a way to set my alignment manually (obviously won't be 100%)without using the clock for calibration.

Clint Buechlein · Post by **Clint Buechlein** » Fri, Oct 15 2021, 7:42AM

I assume by clock you mean dial indicator? If so, no you'll need an indicator, precision pin, and tram bar to do the alignments. If you gather all the tools, you can reach out to our service department at service@thermwood.com for alignment procedures.

-Clint-

Gino Benjamin · Post by **Gino Benjamin** » Sat, Oct 16 2021, 12:51AM

Thanks and yes that's what I mean.
So you not aware of another method to do the head alignment manually with the hand held programmer? To get it more or less aligned?

Clint Buechlein · Post by **Clint Buechlein** » Mon, Oct 18 2021, 10:41AM

You'll need at least a magnetic base and dial indicator to do it.

-Clint-

Gino Benjamin · Post by **Gino Benjamin** » Tue, Oct 19 2021, 1:58AM

Could you take me through the steps please? I've reached out to the email address you gave but never got a response thanks.

Clint Buechlein · Post by **Clint Buechlein** » Tue, Oct 19 2021, 7:56AM

You should have an email from service with procedures.

-Clint-

Thermwood / eCabinet Systems

Manual head alignment

Manual head alignment

Re: Manual head alignment

Re: Manual head alignment

Re: Manual head alignment

Re: Manual head alignment

Re: Manual head alignment