CS40 Cutting Parts Slightly too Small

Philip Martin · Post by **Philip Martin** » Mon, Aug 15 2022, 3:50PM

Hi, we have a CS40 and when I cut out parts from eCabinets, they all seem to be about 1/16" too small. When I nest the parts on the CNC it does show the right dimensions there as well, but when I measure the part its around 1/16" small. Is there some setting or something I'm missing?

Thanks

Kerry Fullington · Post by **Kerry Fullington** » Tue, Aug 16 2022, 9:14AM

Did you check the diameter of your outline tool?

Joshua Caron · Post by **Joshua Caron** » Tue, Aug 16 2022, 11:45AM

Every time this happened to our machine it was because the diameter of the outline tool was incorrectly setup. It would make parts larger or smaller depending on what way the incorrect number was inputted.

Philip Martin · Post by **Philip Martin** » Fri, Aug 19 2022, 1:14PM

Yes you were right, I just replaced the bit with a new one that we got sharpened and it's laser measured. Its cutting exactly the right size now. The bit I had in before was a brand new 1/2" bit but I just measured it with a caliper and it is slightly smaller than 1/2". Now I'll be measuring each bit before I use it.

Thanks!

Thermwood / eCabinet Systems

CS40 Cutting Parts Slightly too Small

CS40 Cutting Parts Slightly too Small

Re: CS40 Cutting Parts Slightly too Small

Re: CS40 Cutting Parts Slightly too Small

Re: CS40 Cutting Parts Slightly too Small