Good Morning (Or afternoon) Everyone,
I recently started having issues with chatter marks along the edges of MDF Doors after replacing the tool holder and collet as well as the 3/8" down shear. The reason for replacing was I had to manually remove a tool from the spindle when the machine wasn't able to eject it out into the tool holder on its own. Between the forums and CNC Automation we resolved that issue, I decided not to use that holder anymore so just ended up replacing the tool holder, collet, and tool its-self but now get nasty chatter marks on 1 or 2 or 3 edges, but not all for edges, leaves me baffled.. (See attached photos.)
Any ideas? Thanks In advance for any guidance any of you may have
Chatter On MDF Doors
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
Re: Chatter On MDF Doors
Tried to post photos but it won't allow me to upload anything larger then 1MB so here is a crappy photo for example :p really the forums should be at 3-5 MB for uploads these days since cameras almost can't take dumbed down photos. And in the end it only allows me to get HEVC photos at a rate of under 1MB so I won't be able to upload pics to help! Sorry folks. Spent 20 minutes trying to get photos for help and give up on trying to post pics on the forums, private message me your email and I'll attach them and email them if you need.......
-
- Guru Member
- Posts: 449
- Joined: Thu, Dec 08 2005, 6:10PM
- Company Name: Williamson Finewoodwork
- Country: UNITED STATES
- Location: Capac MI
- Contact:
Re: Chatter On MDF Doors
Only one thing, causes stuck tools ,
Dirty, Rusty tool holders and collets and spindle
at lot of time, caused by moisture in the air supply,
Dirty, Rusty tool holders and collets and spindle
at lot of time, caused by moisture in the air supply,
Will
http://www.willmade.com
KEG/Intel Core i 7 CPU K875 @ 2.93 GHZ/12G Ram
Dual boot XP PRO/Windows 7 Nvidia Quatro 600 1Gig Ram
http://www.willmade.com
KEG/Intel Core i 7 CPU K875 @ 2.93 GHZ/12G Ram
Dual boot XP PRO/Windows 7 Nvidia Quatro 600 1Gig Ram
Re: Chatter On MDF Doors
Will Williamson wrote:Only one thing, causes stuck tools ,
Dirty, Rusty tool holders and collets and spindle
at lot of time, caused by moisture in the air supply,
I agree! Moisture in air supply and overheating. Anyway with that already taken care of I am looking for advice on the Chatter issue as per post Was just curious if anyone knew why a new tool holder, collet and bit would cause this.