home key in part editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Marcel Thibodeau
- Junior Member
- Posts: 27
- Joined: Thu, Jan 02 2014, 5:46PM
- Company Name: Northwest Kitchen Centre
- Country: CANADA
home key in part editor
Home key in the closed contour mode just takes you to zero,zero instead of zooming out, is this new or some kind of error, I have to go back into part editor to zoom out, I'm sure it wasn't like that before the update. Makes working close up in closed contour pretty much impossible.
-
Clint Buechlein
- Thermwood Team
- Posts: 785
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: home key in part editor
Marcel,
Can you post a sample cabinet that is giving you issues? And a sequence of steps? Myself and another here have tried to make it misbehave, but it seems to be working as expected for us. It would be worth it to restart your computer (not power off and power back on), and also check for graphics card driver update from the manufacturer's site.
-Clint-
Can you post a sample cabinet that is giving you issues? And a sequence of steps? Myself and another here have tried to make it misbehave, but it seems to be working as expected for us. It would be worth it to restart your computer (not power off and power back on), and also check for graphics card driver update from the manufacturer's site.
-Clint-
