Hi, I was cutting a big job with our CS40 and seemingly randomly the machine will cut about 1/4" deep into the spoilboard. This is the second job it has happened to now, it was a fairly large job with 33 sheets nested and it happened on sheet 28. Every other operation works fine, but when it starts the outline cut it goes way too deep. I attached the .TWD and .CNC files below. Any help would be appreciated as I need to get this job finished!
Thanks
Philip
Cutting Outlines too Deep
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Philip Martin
- New Member
- Posts: 12
- Joined: Wed, Jun 15 2022, 12:25PM
- Company Name: Barr Line Woodcraft
- Country: CANADA
- Contact:
Cutting Outlines too Deep
- Attachments
-
- Files.zip
- (1.37 MiB) Downloaded 1056 times
