hi I'm new to vcarve and dealing with post processors and found these posts that clint posted.
the G52L1 on line 105 i have a question about
why is it here? i don't have a fixture offset set up but it moving my pieces on the Y axis down not tight to the end
if anyone else has tips or tricks please post them
vcarve post question
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Thomas strembitsky
- Guru Member
- Posts: 306
- Joined: Fri, Jul 27 2012, 12:30PM
- Company Name: true form cabinets
- Country: CANADA
- Contact:
vcarve post question
Intel(R) Core(TM) i-13700K @ 2.70GHz 32.00 GB RAM
Windows 11 Professional 64-bit
http://www.trueform.ca
CS43 cnc
Windows 11 Professional 64-bit
http://www.trueform.ca
CS43 cnc