Build 3 printing still shuts down program

[Lamar Horton]

Faulting application ecabinets.exe, version 6.037.0, faulting module ntdll.dll version 5.1.2600.5512, fault address 0x00042b9f.

[Lamar Horton]

OK, That "test" job I posted still shuts down the program when trying to print from the LDE, but my latest job printed just fine. Perhaps it was because the test job was done in the previous build and the latest job done in the current build. Sound good?

[Ryan Callahan]

Lamar,

Thanks for the update. I just tested your posted job again, and still, everything prints fine for me. I do not think it has anything to do with a previous version, but you never know.

If the problem continues, be sure to let us know with exact steps or files to attempt to get it to happen.

Thanks.

[Lamar Horton]

It did it again, but this time I figured it out.

I have 4 drawings I am trying to print. First drawing I had the arrows set to 1/16 x 1/32, no problem. 2nd-4th I had to arrows set to 0 x 0 and the program shut down. I reset the arrows back to the previous values and voila printing again.