Can someone take a look at this job and let me know why this countertop is moving 3" after I take it to the PE and cut it.
Thanks,
-John
Problem with a moving countertop after PE cut
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
JohnLashuay
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
Problem with a moving countertop after PE cut
- Attachments
-
- Oakly-Kitchen.esj
- (7.15 MiB) Downloaded 275 times
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: Problem with a moving countertop after PE cut
It must be in the program
I played with it for about 2-Hr's
I did make a DXF for you with the sink cut out
I played with it for about 2-Hr's
I did make a DXF for you with the sink cut out
- Attachments
-
- Snap1.jpg (52.17 KiB) Viewed 2381 times
-
- Snap2.jpg (42.57 KiB) Viewed 2381 times
-
- Base Cab_11-11-09.zip
- (369.98 KiB) Downloaded 253 times
-
JohnLashuay
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
Re: Problem with a moving countertop after PE cut
Thanks George for looking into this!! As much as I tried, I couldn't find a way around it so I deleted the back splash and just moved the top after I modified it.
Thanks again!
-John
Thanks again!
-John