Do any of you guys warm up your cnc before machining anything? I was reading through the machine manual the other day and seen a section on warming up the machine before use. If so, do you run a certain program to do this or is there a way of just turning on the spindle whilst in the home position?
Dale
Machine warm up procedure ?
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Dale Wills
- Senior Member
- Posts: 190
- Joined: Mon, Oct 10 2005, 11:09PM
- Company Name: none
- Country: AUSTRALIA
- Location: Camperdown, Victoria, Australia
-
Joe Soto
- Guru Member
- Posts: 367
- Joined: Thu, May 19 2005, 7:50PM
- Company Name: Fancyridge Wood Products LLC
- Location: Greensburg, Ky
Re: Machine warm up procedure ?
Dale,
Here is the one I use. You may need to modify it slightly for metric.
Joe
Warm up Program
by Michael J Starry » Wed, Mar 19 2008, 8:24AM
HERE IS THE WARM UP PROGRAM:
(PROGRAM - SPINDLE WARM UP ROUTINE)
(DATE - DEC-28-06)
G90
G00 X0. Y0. Z0.
(PICKS UP TOOL 2 AND RUNS FOR 10 MINUTES )
(GANTRY AND HEAD MOVE TO LOCATION TO ALLOW FOR GREASING)
S2000
T2 M03
G00 X30. Y30. Z5.0
M31
S2000
G04F100
S4000
G04F100
S8000
G04F100
S12000
G04F100
S18000
G04F100
S24000
G04F100
M05
G00 G45 Z
G43 (Tool Length Comp. Off)
G990
G00 X0. Y0.
G09F1
M49
M02
Here is the one I use. You may need to modify it slightly for metric.
Joe
Warm up Program
by Michael J Starry » Wed, Mar 19 2008, 8:24AM
HERE IS THE WARM UP PROGRAM:
(PROGRAM - SPINDLE WARM UP ROUTINE)
(DATE - DEC-28-06)
G90
G00 X0. Y0. Z0.
(PICKS UP TOOL 2 AND RUNS FOR 10 MINUTES )
(GANTRY AND HEAD MOVE TO LOCATION TO ALLOW FOR GREASING)
S2000
T2 M03
G00 X30. Y30. Z5.0
M31
S2000
G04F100
S4000
G04F100
S8000
G04F100
S12000
G04F100
S18000
G04F100
S24000
G04F100
M05
G00 G45 Z
G43 (Tool Length Comp. Off)
G990
G00 X0. Y0.
G09F1
M49
M02
