build 3

Chris B Campbell · Post by **Chris B Campbell** » Fri, Mar 26 2010, 5:37PM

Downloaded build 3 get options to Modify, Repair, or remove. tried modify then tried repair. Open e cab and still in Build 2. What am I missing? Do I need to completely remove?

Thanks,
Chris

Derrick Monson · Post by **Derrick Monson** » Fri, Mar 26 2010, 6:48PM

What Operating System?

Rick Deskins · Post by **Rick Deskins** » Fri, Mar 26 2010, 7:29PM

Make sure you dont have ecabinets open, and then run the repair.

Chris B Campbell · Post by **Chris B Campbell** » Sat, Mar 27 2010, 10:20AM

XP Pro. No E cabs was not open... Thing is I have downloaded many other builds in V5 and 6 with no problem but for some reason I cannot get this build 3 to take?

Thanks again,
Chris

Chris B Campbell · Post by **Chris B Campbell** » Sat, Mar 27 2010, 10:30AM

Tried again, used repair option, everything goes along as if it's all working fine, hit finish, open e-cabs get the "Verify" window hit verify, e-cabs opens and across the top I get "eCabinet System 6.0 Build 2 - Untitled".
So what the heck am I doing wrong!

Chris

Gary Puckett · Post by **Gary Puckett** » Sat, Mar 27 2010, 12:07PM

Chris,

Open eCab, click on the help tab and then click on about eCab. What does it say

Gary

Chris B Campbell · Post by **Chris B Campbell** » Mon, Mar 29 2010, 6:22PM

6.0 Build 2

Thermwood / eCabinet Systems

build 3

build 3

Re: build 3

Re: build 3

Re: build 3

Re: build 3

Re: build 3

Re: build 3