I have experienced some long rounding showing in control nesting. I am not sure that this might be the reason but sometimes I get no response from CN. Shop Bot and Cn show difference in number rounding when loading the same job. I don't really want to experiment but I will try and load in on some of the older versions of CN just to see if there's something happening.
Will keep you posted.
CN load rounding to 6 or 7 digits after decimal point
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Georgi Baltov
- Guru Member
- Posts: 341
- Joined: Sat, Mar 10 2007, 7:31PM
- Company Name: Top Notch Cabinets
- Country: CANADA
- Location: Oakville, Ontario
- Contact:
-
Georgi Baltov
- Guru Member
- Posts: 341
- Joined: Sat, Mar 10 2007, 7:31PM
- Company Name: Top Notch Cabinets
- Country: CANADA
- Location: Oakville, Ontario
- Contact:
Re: CN load rounding to 6 or 7 digits after decimal point
One machine nested fine the other stop responding. I think 30 min is enough time for it to do the job. Done on CN 5.57. Don't know what the difference between the two is but the one that wouldn't do it freezes after the final sheet is written on Nesting progress. Have no clue
Top Notch Cabinets
http://www.topnotchcabinets.com/
http://www.topnotchcabinets.com/
-
Ryan Hochgesang
Re: CN load rounding to 6 or 7 digits after decimal point
Georgi,
If you supply the EXPORT file from each machine and specify what the TWD control software version is, we will have a look here.
Thanks!
If you supply the EXPORT file from each machine and specify what the TWD control software version is, we will have a look here.
Thanks!
