How do you do this?

JohnLashuay · Post by **JohnLashuay** » Fri, Aug 06 2010, 9:30AM

Hi Guys!

Here is a cabinet that I need to CNC. I don't know how to cnc the diagonal shelves.

Any ideas?

Thanks,
-John

Gary Puckett · Post by **Gary Puckett** » Fri, Aug 06 2010, 10:30AM

You will probably have to old school and use the tabel saw.

Gary

JohnLashuay · Post by **JohnLashuay** » Fri, Aug 06 2010, 10:34AM

Thanks Gary!

I was afraid that someone would say that.

Josh Rayburn · Post by **Josh Rayburn** » Fri, Aug 06 2010, 11:39AM

You can profile the edge of the shelves with a 45 chamfer tool, and use that actual tool to cut it. There are some funky settings and things you have to do to get it to actually work, but I've been successful. There actually was a good post about this a while ago, you may be able to find it with a search. It was explained better in that post than I can explain it....Let me know if you don't find it.....
jnr

George Davidson · Post by **George Davidson** » Sat, Aug 07 2010, 8:43PM

Hi John
I could not open the esa on my computer

Thermwood / eCabinet Systems

How do you do this?

How do you do this?

Re: How do you do this?

Re: How do you do this?

Re: How do you do this?

Re: How do you do this?