Please help
Moderators: Jason Susnjara, Clint Buechlein, Jason Susnjara, Clint Buechlein
-
Steven E Shmucker
- New Member
- Posts: 5
- Joined: Fri, Aug 06 2010, 8:47AM
- Company Name: Cedars
Please help
When doing a nest a warning sign comes up and say can not nest the back. gives me the dimensions. What is wrong here. Thanks so much.
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: Please help
Steven,
I think that this is more of a question for the 3 Axis Machine Forum since it deals with Control Nesting. This particular forum is for custom tooling profiles used within eCabinet Systems.
In response to your question though - check your sheet material size. It could be that your back component cannot be nested within the defined sheet size. Remember that you have to consider the buffer or collar around the edge of the sheet. Another thing, if applicable, is grain and the grain direction on the part itself.
Hope this helps....
I think that this is more of a question for the 3 Axis Machine Forum since it deals with Control Nesting. This particular forum is for custom tooling profiles used within eCabinet Systems.
In response to your question though - check your sheet material size. It could be that your back component cannot be nested within the defined sheet size. Remember that you have to consider the buffer or collar around the edge of the sheet. Another thing, if applicable, is grain and the grain direction on the part itself.
Hope this helps....