batch lists not saving

[Alex Bowler]

Hi i just downloaded build 9 and i created a list of panels in the batch (cabinets with only the side remaining, i do this so i can display taping instructions on stickers) i saved it but when i went open it it just sent me back to the main page?

[Scott G Vaal]

Hi i just downloaded build 9 and i created a list of panels in the batch (cabinets with only the side remaining, i do this so i can display taping instructions on stickers) i saved it but when i went open it it just sent me back to the main page?

I am not able to reproduce this. Here is what I tried:
1.) I created a cabinet that is only a right end with edge banding
2.) Added 8 different sizes to a batch list
3.) Saved the job
4.) reloaded the job

If you repeat your steps will it happen again? If so, I may need your cabinet and the steps you take.